Dräger X-plore® 8000 Filter K2 REF 6739550

The Intended use for this filter is for respiratory protection against particles, vapours and gases in combination with the Powered Air Purifying System X-plore 8000 and a specified face piece.

The scope of protection as indicated by product documentation, technical standards and installed application rules.

Compliance relevant standards: EN12941:2009-02, EN12942:2009-02 (System approval in combination with the powered air purifying respirator X-plore 8000)

Working principle: Gases and vapours are removed from the ambient air by adsorption onto the sorbent (activated carbon), particles are filtered by the micro-glas fibre filter.

• Protects against gases and vapors of organic compounds with a boiling point greater than 65°C
• Protects against inorganic gases and vapors, such as chlorine, hydrogen chloride, and sulfur dioxide
• Protects against particle hazards

The Design is setup with Two angular gas filter cartridges which are sealed within the nearly angular filter housing. The gas filter parts contain a welded activated carbon bed. The particle filter is positioned in front of the gas filter section in the direction of flow and is welded to the gas filter part. A gas-tight connection of the individual components results from welding. There is a molded gasket on the curved bottom. The whole filter is sealed in a water vapor impermeable barrier bag. The seal is equipped with a blue transport protection against undefined deformation due to the vacuum in the barrier bag.

Connection to Powered Air Purifying Respirator: The filter is inserted into the fan unit (with the color marking pointing downward toward the device) until it snaps audibly into place. Then the splash guard lid is set over the filter until it snaps audibly into place.

Please note that the system usability is only suitable for use with the Dräger X-plore® 8000 Powered Air Purifying Respirator.

Dräger X-plore® 8000 Filter Data Sheet

Order Code: RES3023